Royal Engineer ( RE ) Officer 's Gilt and Silver plate Matched Collar Badges
A stunning pair of high gilt and silver plated two part construction metal collar badges with two original lugs to each. Circa 32mm tall. Note nine flames as worn by RE as opposed to seven as worn by RA. Slight verdigris to reverse of one badge.
read more
Royal Engineer Officer's Matched Pair of Fire Gilt Collar Badges, stunning
A super large pair of matched collar badges in fire gilt and amazing condition. Two original lugs to the reverse. 9 flames to each. Circa 4.7cm tall.
Churchill & Westlake No 351 refers.
read more
WW2 Royal Electrical & Mechanical Engineers ( REME ) 1st Pattern Brass Cap Badge
A brass cap badge to the Royal Electrical Mechanical Engineers with original slider to the reverse. In good condition. First introduced in 1942, replaced with second pattern in 1947.
Coll.
K&K Vol. 2 No 2127 refers. read more
Royal Army Medical Corps ( RAMC ) Officers Silver plated and gilt Cap Badge, pre 1953 - Gaunt London
An attractive and well made die cast cap badge with two original silvered long lugs (slight wear) to the reverse and embossed to the rear with the maker's details JR Gaunt London. King's crown, so pre 1953. In good condition with slight tarnishing to plate. Gilt still reasonably bright.
read more
Royal Army Service Corps ( RASC ) Other Ranks Cap Badge - George V
Scarce cap badge with original slider. Slight touch of verdigris to bottom right of star, otherwise in very good condition. For some reason these were not issued until later during his reign and are surprisingly hard to find.
Coll read more
Royal Army Pay Corps ( RAPC ) Bi-metal Beret Cap Badge
King's crown smaller pattern bi-metal cap badge as worn in the beret with original slider. Some verdigris to slider but will clean up. Circa 3.4cm tall and 3.6cm wide. I was told by vendor that this particular badge was worn by an officer. It came with the silver and gilt collars listed below, but is not of the same finish or quality.
read more
Royal Army Pay Corps ( RAPC ) Officer 's Matched Facing Pair of Gilt and Silver Plated Collar Badges
A wonderful matched pair of Royal Army Pay Corps Officer 's two part construction fire gilt and silver plated collar badges. Facing and matched pair, with two original lugs to the reverse of each. Circa 2.7cm tall and 3.1cm wide.
Coll
read more
Royal Engineers Officer's OSD Collar / Side Cap Badge - 10 flames
An unusual 10 flame pattern R.E. single collar badge (also possibly a side cap badge). Two original lugs to reverse. Circa 4.7cm tall. In good condition with sharp detail.
Coll. read more
Royal Army Service Corps ( RASC ) Officer 's Chrome, Gilt and Enamel Queen's Crown Cap Badge, Post 1953
An officer 's two part construction cap badge, some minor service wear, but enamel intact. Circa 4.8cm tall and 4.2cm wide. Two original lugs to the reverse and maker marked JR Gaunt London on reverse. An attractive badge. read more
16.00 GBP
Territorial Army Battalions Matched Pair of Chaplains Silver Collar Badges - Jennens
A stunning matched pair of die cast unmarked silver collar badges each with two original loops to the reverse and both maker marked J&Co, dating them to pre 1922. Circa 3cm tall. It is interesting to note that under AO 338 of 1925, Chaplains of the TA were permitted to wear badges and buttons in silver and white metal, but this only regularised what had been being worn prior to this d... read more